There is a spot by the ear but that will also disappear before finish. There are a couple of places on the lettering on this board that will need fixed but they are small and won't be a problem. I do V-carve inlays if I need sharp points for the inlays but I also modified the procedure from what the Vectric tutorial shows, my machine would not cut the pockets and inlays good enough for a tight fit. This will also have epoxy inlays and I'll be using the 0.0625 end mill and a 45 deg V-bit for those inlays.
I am using a 0.0625" upcut end mill with 0.25" cut length and a 0.25" end mill for a large area clearance tool. I am doing this board with the straight inlay toolpaths for pocket and inlays. Click to expand.I use Vectric Aspire but this could be done in Vcarve except for outputting pictures of the board with inlays installed.
0 kommentar(er)
